PRODUCT DESCRIPTION
WOODPOL WOOD STAINS are high quality solvent base stains which are used to give wood another color without masking the structure of the wood substrate, hence enhancing wood grains & texture. It penetrates in to the wood leaving a Natural look & so natural choice where aesthetic consideration is foremost. Generally they are applied directly on to the wood substrate, prior to filling or lacquering process.
Available in seven rich wood tone colors & also basic color like Red, Black, Blue, Orange, Yellow Green.
These stains can inter-mix to make your own unique stains.
APPLICATION GUIDE
| 1 | Recommended Uses | Interior wood applications |
| 2 | Product Description | Solvent base wood stains. |
| 3 | Appearance | Transparent colors. |
| 4 | Consistency | Ready to use but can mix with good quality NC Thinner. |
| 5 | Method of application | By ragging, spraying or mixing with lacquer. |
| 6 | Recoating time | 10 - 20 minutes. |
| 7 | lammability | 30 - 45 minutes. |
| 8 | Packing | 60 - 70 sq.ft./coat/Lt, depending on wood type & porosity. |
| 9 | Shelf life | One year in unopened conditioned |
| 10 | Packing | 100 ml, 1 Ltr, 5 Ltrs, 20 Ltrs. |
| 11 | Shades available | Natural Wood , Rose wood, Walnut,LT Teak, Dark Antique Pine, Red Mahogany , Light Indian Oak,Red, Yellow, Orange, Brown, Blue, Green, Black, Wengie ,Carrom Black |
PERFOFMANCE
» Provides fast drying.
» Ease of application.
» Controlled penetration with uniform color.
» Leaves no lap mark or streaks.
» Enhance natural beauty of wood.
APPLICATION PROCEDURE
» Wood surface must be dry and free of dust and loose particles. Sand the
surface along grains with emery paper #180 followed by smooth sanding with #320 or 400.
» All stains are designed primarily for use on new wood.
» Dip a clean sponge or folded cloth in to the stain and squeeze out the Excess. Using longs continuous strokes, apply the stains to a small area at a time, following grain pattern of the wood. While application stop at a natural break to maintain a wet-edge to achieve uniform, lap-free, streak less finish.
» The appearance and color of the stain will vary depending up on the wood porosity.
» Apply additional coat at the interval of 10 – 15 minutes for desired wood tone color. To lighten the color, add good quality of NC thinner.
» Do not sand the stain coat. Allow drying time of 30 – 45 minutes before over coating.
» Apply finish coat or top coat of sealer, varnish, shellac, melamine or PU.
