| PRODUCT | PRODUCT CODE |
| Clear Glossy | 15 |
| Clear Matt | 16 |
| Glossy Color | 18 |
| Tone matt color | 18 |
| Tone |
PRODUCTS DESCRIPTION
WOODPOL wood finish is a Single Pack, air-drying Polyurethane system for wood & wood substrate. This clear coating system brings out the grain Pattern
& surface texture of wood so well to make it look splendidly natural & show out real charm. Not only it preserves & enhance the natural beauty of wood grain, but also protects from heat, water, tea & coffee stains & insect attack.
APPLICATIONS PROCEDURE
» Wooden article to be coated must be dry & free of dust and loose particles. Prepare smooth surface by sanding with emery paper #180 followed by #320.
» Apply good quality of wood filler using a musclin cloth or putty knife. Remove excess filler & allow to dry for 2 - 3 hours. Sand with emery paper #180 followed by #320 between application of successive coat.
APPLICATIONS GUIDE
| 1 | Recommended Uses | Interior wood applications |
| 2 | Product Description | One Pack Polyurethane modified clear finish. |
| 3 | Supply Viscosity | 60 ± 30 sec. on ford cup B4@30 °C. |
| 4 | Thinner Recommended | TH - 601 or good quality mineral Terpentine |
| 5 | Thinner intake | For Brushing - 5 - 10% by volume. For spraying - 20 to 25% by volume. |
| 6 | Solid | 45 ± 2 |
| 7 | Specific gravity | 0.89 ± 0.02 For spraying - 20 to 25% by volume. |
| 8 | Method of applications | Brushing/Spraying. |
| 9 | Spray Pressure recommended | 30 - 40 PSI |
| 10 | Recommended DFT | 25 - 30 microns |
| 11 | Drying time @ 30 ± 2 °C Relative humidity of 60 ± 5% | Surface dry - about 1 hour
Hard dray - 24 hours. |
| 12 | Recoating time | 6 - 8 hours @ 30 ±2 °C& Relative humidity of 65% or below. |
| 13 | Theoritical covering | 8 -10 m2 / litre/ coat by Brushing. |
| 14 | Flash point | At or Above 30 °C. |
| 15 | Shelf Life | 6 months in Unopened conditions in original container when stored in cool & dry place @ 25± 5oc |
| 16 | Shades available | Oak Yellow, Red Brown, Walnut, Rose wood. |
| 17 | Packing | 200 ml, 500 ml, 1 ltr, 4 ltrs, 20 ltrs. |
» Select finish available in Clear Matt, Glossy or in transparent shades like Oak Yellow, Rose wood, Walnut & Red Brown.
Apply one or two coats of WOODPOL TRANS WOOD PU wood finish and allow to
dry for minimum of 6 - 8 hours. Light sand with emery paper #320 between application of successive coats.
» Light sand with emery paper # 320. Clean the surface free of dust, grease & loose particles & follow step no (2) & (3) also old polish or coating can be removed completely by using WOODPOL Paint & Varnish Remover.
