WOOD COATINGS

WOODPOL Interior PU (Acrylic)

APPLICATIONS GUIDE

  Mixing ratio Woodpol Interior PU - Base 80 parts by volume
Woodpol Interior PU - Hardner 20 parts by volume.
Woodpol Interior PU - Thinner 15 - 30 parts by volume.
  Spray Viscosity   15 - 20 secs on Ford cup B4@ 30 °C.
  Maturation time   30 minutes
  Pot-life of mixture   3 - 4 hours at 30°c.
  Method of application   Spraying.
  Spray Pressure   30 - 40 psi.
  Recommended DFT   30 - 35 microns per coat.
  Drying characteristics @ 30°c & relative humidity below 75%   Touch-dry            30 minutes.
  Dust-free             2 hours.
  Tack-free             3 hours.
  Sanding-dry          8hours.
  Hard-dry              Overnight.
  Fully Cured           7 days for solvent &chemical resistance.
  Recoating time   8 hours @ 30°c.
  Theoritical covering capacity @ 30 micron DFT    8 - 10 m2/litre per coat dependent on method of application. 6 months in unopened condition in original
  Shelf life   container when stored in cool & dry place, @ 25±5°c.
  Packing   250 ml, 500 ml, 1ltr, 20 ltrs.

HEALTH AND SAFETY INFORMATION
»  Handle products in areas of good ventilation. Avoid inhaling vapours since product contains volatile organic solvents.
»  Wear normal protective overalls. Solvent resistant hand gloves, eye goggles are recommended. Avoid skin contact.
»  The product is flammable and the container should therefore be kept away from fire & spark or any ignition source.

STORAGE, HANDLING & DISPOSAL
»  Store in original container in cool, dry & well ventilated place.
»  While handling, avoid inhalation & skin contact. Force ventilation or fresh air mask should be used in confined spaces..
»  Disposal in land filing & not in drain or water ways.

WARRANTY
The information contained in this sheet is based on our experience and laboratory tests and true to the best of our knowledge. However no warranty, expressed or implied, arising out of the use of our product is given as we have no control over the quality of substrate used nor the application conditions and methods. Customers are advised to carry out their own test to judge the suitability of our products for the recommended applications. The information contained here in is subject to change without further notice.